The right sensor for every monitoring challenge
From single-station research setups to continent-wide networks – SeismiQ sensors are built for long-term field deployment, open-standard data access, and zero-maintenance remote management.
One platform. Any scale.
Both sensors run the same open-source SeismiQ firmware, so your team works with a single toolchain whether you operate two nodes or two hundred. Signal processing runs on the sensor itself – delivering real-time data products without cloud dependencies or bandwidth bottlenecks.
Configure, update, and monitor every sensor remotely through our management platform. No VPN, no site visits. New algorithms and firmware updates roll out securely over-the-air, keeping your entire network current without touching the hardware.
SeismiQ HiDRA
Seismic networks • Geothermal monitoring • Research institutions
HiDRA is a research-grade short-period seismometer that captures the full picture – from microseismic well-injection events to regional earthquakes – in a single instrument. Adjustable pre-amplification and sampling rates let you tune sensitivity to your target signal without swapping hardware.
- 3-component 1-second seismometer – detects local, regional and teleseismic events
- Ultra-low noise 24-bit ADC (139 dB) – resolves the weakest ground motion signals
- Selectable 50 / 100 / 200 / 400 / 500 Hz sampling and 1×–4× analog gain
- Wide voltage input (9-36 V) – compatible with solar, battery and mains power
- External GNSS time synchronisation – sub-millisecond timing accuracy
- Industrial NAND storage – data integrity under harsh field conditions
From €3 600
SeismiQ MEMS
Structural health monitoring • Earthquake early warning • Large deployments
MEMS makes it practical to instrument an entire building, bridge or campus at a fraction of the cost of traditional seismometers. At just 1 W, with optional PoE, nodes install wherever there is a network cable.
- Low-noise 3-component 20-bit accelerometer – sensitive enough for seismic event detection
- Selectable 50 / 100 / 200 / 400 / 500 Hz sampling – adapts to structural and seismic use cases
- WiFi and Ethernet – flexible deployment in buildings or field enclosures
- 1 W Power over Ethernet – single cable for data and power, no extra wiring
From €550
Everything you need to evaluate and deploy
Full technical specifications, wiring diagrams, firmware setup guides, and FDSN integration instructions - all in one place. Most teams are up and streaming data within a day.
Visit Documentation